Recent content by MoRoToRiUm

PB buster to loosen it, and then clean/sanatize it quick before re-assembly?

If you are looking at a 5 pounder option, consider larger if your setup won't be hindered with the size of the tank- I say this because it is cheaper by volume to fill a larger tank then a small one (my local place is $10 for a 5 pounder, $14 for a 20 pounder). Most places are like that, but...

"S M R T. I mean S M A R T..." My mom always said I was special :drunk:

Own Springfield XD sub-compact 9mm- LOVE IT! My only complaint are the safety indicators- the top one works as it's supposed to, but the front and rear indicators to show that a round is in the chamber always seem to stay the same. I checked out the local store and all of them are like mine, so...

+1, but I have my system balanced at 8-12 PSI depending on the beer. Make sure you bleed the excess pressure when you drop it to your serving PSI.

2 3/4 hole saw from lowes; I used aluminum tape as well (was going to get HVAC but it was more expensive). Post your results in the 'Show us your kegerator' thread!

Balancing your system is always hard to start off with... Hope it works out! Keep us posted :mug: PS How's that tank treating you?

Clean mine well after brewing, and then stick it in my starsan solution bucket for about 15 minutes before I go to use it. No problems, and I don't have to cool down the hot copper you get by boiling it (even though copper is great at heat dissipation).

Fixed that for you

I would go with a hole cutter if I were you. Drill a small pilot hole dead center, and have at it. You will have jagged edges with a spade bit. I would definitely add a piece of wood for backing to support your shanks (guessing you are putting faucets directly on the door). Hope this helps! Post...

Let us know how the O rings work- Pressurize it to 20+ PSI and let us know if/where it leaks. Good luck!

Very nicely done! Make sure you post this in the https://www.homebrewtalk.com/f35/show-us-your-kegerator-29053/ thread!

In case it goes bye bye- Fine, Don't ****ing Hire Me, You Can't Handle My **** Date: 2008-12-02, 10:34PM CST What the **** people! I need a mother****in job, and I have a resume that says I am ****ing fit to be your goddamn front desk/administrative assistant. I have applied to a ton of jobs...

Looking good! I think you posted before about this- about an 8ft run, right? :mug:

I have a Victory Brewery one that's been sitting in my apartment forever now... The local brew store will gladly take it back though, so I can't ethically write it off...