Recent content by mdh384

It is looking like the problem was a gas leak: one of the kegs kicked, and just out of curiosity i left it sitting, detached from the CO2 and faucet line, for a couple days. when I went to relieve pressure to open the keg for cleaning, there was no pressure. The leak was slow enough that soapy...

:mug: From my first post:

And by the way, myths, un-truths, etc, are now known as "alternate facts". heh.

my serving pressure is ~10psi, with 12' accuflex tubing length. Issue is, I will get slugs of gas on every upward facing loop of the beer line, including straight out of the keg, so I don't think my problem is tubing length. Raising serving pressure does not seem to have an affect on the...

So, new parts arrived and installed, the problem is NOT fixed. Tried doing the pressure release and line purge again, just to make doubly sure it's not over-carbonated, still getting gas bubbles (since I no longer know if it's CO2 or air...) in the line. I am officially...

Well it remains to be seen if this fixes the issue. Parts are still en route, I will hopefully know if that was the problem once the parts arrive.

I was skeptical, but decided to pull apart my beer line since I've got no other ideas. I am using the accuflex beerlines and push-connect adapters. Since the beer line has been holding in to the connector, i figured it must have been fine... but maybe not: the keg connector, immediately after...

So the CO2 vent of the keg and slow purge of the line has not worked... Any other ideas?

Thanks, I'll give this a go

I've been troubleshooting an issue with my kegerator, and was hoping for some ideas on how to fix this issue. The symptoms: after sitting for a while, as little as 15 minutes, I get a slug of CO2 in my beer lines. This causes problems with foaming, and frustration when I want to drink my...

my $50 CL freezer, turned keezer. the guy I bought it from started the stickers, I've just been adding to it. the collar is waterlox'd cherry, with some foam insulation on the inside. my drip tray is a temporary solution until I find some stronger magnets to stick the metal one I have on the side.

clean glass, tasty beer!

what are you using to remove the label adhesive? i tried an oxyclean soak and it didn't work.

on tap this week...

happy yeast seem to be fast yeast. the beers i've done using a large starter of wlp001 have all finished fermenting in under a week using a fermentation fridge and O2 injection before pitching. my most recent AG IPA was dry hopped on day 10, cold crashed on day 11, and kegged on day 14. 3.5oz of...