Ya that is the one. I should have looked a little harder at the link I posted. I was looking at a couple of them and the descriptions threw me off. They all looked the same but one said mega board.
Thanks
Ya that is the one. I should have looked a little harder at the link I posted. I was looking at a couple of them and the descriptions threw me off. They all looked the same but one said mega board.
Thanks
I'm just about to dip my toe into this. I saw this on amazon and was wondering if it would work.
Solu UNO R3 Atmega328p Development Board + USB Cable Compatible with Arduino UNO R3 Mega 2560 Nano Robot / New UNO R3 Rev3 Development Board Atmega328p Atmega16u2 AVR USB for Arduino...
I'm thinking of doing pressurized fermentations and was wondering if anyone else has with the brewpi. I was thinking of taping and insulating the beer sensor on the side of the keg. Just not sure if the keg would be more like ambient temp as opposed to beer temp.
If you can afford a 15 gal kettle; I would go with that. I find that even doing only 5 gal batches I need 9 gal of water. You will need to be quite careful with the 10 gal pot but the 15 will be just the right size to fit grain and water and no worries of boil over.