Recent content by juic

The tri clamp heating element is awesome I would definitely go that route.

I read once before that it hasn't been tested for good grade sage and they don't recomend it. Just my 2 cents:drunk:

60 grit flapper wheal it is Turned out pretty good. Not the same weld but it looked just as bad Does anyone know if the ceramic dremel bits would work also??

What's the best way to clean up some welds?? I do have a dremel and a grinder but afraid if I use the grinder ill take to much off and be screwed. I figured I could get in there with the dremel and clean it up a bit but what kind of attachments would I use. Maybe a 80 grit flapper wheel Or...

Will this repasivate or do I need to grind it down so it's shiny then repasivate? Looks like he kinda grinded the top but the bottom he couldn't see he figured was good enough I guess.

Cool thanks

So a question. I started scrubbing on the inside with bkf last night. Do I need to do the outside of the weld also or just the inside? If I do the outside should I buff it first then repasivate?:confused: Also is there a way to know its pasivated? I don't want to put my coil in the hlt and...

All three:tank:

Mt

Hlt

Boil kettle

Another inside

Inside

So I found a local guy in town that did all my welds for free :rockin: This is what they look like. I know not the best looking but for free you can't beat the price:ban: I figure I hit all the inside with bkf and I should be good. All the welds on the insure look about the same.

I'm stoked can't wait :rockin: