Recent content by hooks

:mug:

subscribed

here's mine I finished a couple months ago.. https://www.homebrewtalk.com/f51/my-scratch-built-grain-mill-258265/

HI Hit the TWit, the dimensions are standard to the design that Lonnie Mac used in his article in BYO magazine. I planned for installing electrical ect... later but decided I liked it the way I built it. I wouldn't change anything, maybe leave off the pilot light option on the two burners... I...

nice job on the fab of your mill!! congrats..

Nice work Neddy..

12 Volt battery with an inline 50amp breaker between the switch and motor...

It's a 12 volt, 600 Watt gear motor rated at 836 inch pounds which translates to roughly 70 foot pounds, spins at 40 RPM.. thanks for the kind words..

I just finished building my grain mill. I found a 12 volt motor that puts out 70 foot pounds of torque, a long ways from the first gear motor I tried... I had a guy in our sheet metal shop design the grain funnel so it holds roughly 20#'s of grain. The grain funnel empties into a soap dish...

If you really want to drive both rollers, get an o-ring that spans the gap between the rollers enough so that the driven roller drives them both... that's probably the easiest other than using 1 motor for each roller... which is probably the most expensive... as others have said, just drive one...

HI from Madison.. Prosit!!

Nice Grain Mills everyone!!

More pics to follow....

I built my stand out of .063 x 2 x 2 steel tube, stainless tube in .063 wall is plenty strong for this... go for it.

Thanks, Guys....