Yea, my search turned up the same. McMaster is outrageous and if I had done Duda I'd end up having to add an extra part for my purposes.
Ended up getting a brass 3/4" FGHT to 1/2" MNPT
Throwing some parts together to hang my hose off the side of my kettle for filtered water. Hose adapter to...
For those interested in another Keezer build!!!!
I did a fair amount of research, as most people do, and put my own spin on it. I’ll attempt to detail the components used and where and how much I bought them for (all prices include any tax/delivery). I didn’t go the thrifty route...
I just got my A419 for my keezer. It came set for Cooling Cut-In. I had to change it to Cooling Cut-Out. You have to open it up and move a jumper from one pin setting to another. There was a diagram in the instructions I followed.
I have 3 of these. Not sure you'll find a better deal on new 5 gal ball locks
http://www.homebrewing.org/AIH-New-5-Gallon-Corny-Keg-Ball-Lock_p_5100.html
I ended up swapping liquid assemblies like 5 times before it flowed well enough... Decreasing less hop debris on each swap.
- depressurize
- unscrew and remove liquid out and dip tube parts and replace with sanitized ones
- repressurize and attempt to serve
- do a bunch of times
I'm going to...
Thanks for the advice. Think it's worth swapping out dip tube and poppet assemblies? Or will it just reoccur?
I did do a 3 oz dry hop.... Maybe bags next time
I don't know about the other kegs. First time using them.
I did push the liquid poppet down and got beer/foam
I'll try another disconnect, but if sanitizer flowed through everything fine prior then I assumed I could push beer through as well.
I mean I pushed those suckers down....
PLUS I pushed sanitizer through the system prior to racking with no issues. Because of that I don't think the disconnect is the issue.
Suppose I'll swap it out anyway to try