Recent content by BrocTree

A spunding valve could be handy if the beer is overcarbed--you could set the spunding valve to the appropriate pressure (based on the carb chart and storage temperature) and let it sit for a few days until it re-equilibrates. Might be easier than pulling the prv continuously.

That makes sense. I don't think I specifically need to know exact the voltage/amperage of the heating element, so I'll probably just wire for detecting the totals. Because everything is 240V (vs a mix of 240 and 120V), then I could put it around either the incoming L1 or L2 and get the same...

Thanks for sharing this--I didn't know that the MVA-22R existed. I love the idea of seeing how many amps are being pulled in real time. At first I was confused by where this was the wiring diagram before I realized that it's powering the AC current transformer (which will need to go around one...

Thank you so much! Just to make sure I understand correctly--I could use this plan with just removing the pump (and associated wires). There would be fuses before and after the main power on switch (and it looks like I could use 1amp fuses for all of them, because it was the pump that required...

Hi, I do 5 gallon eBIAB and was hoping to get more insight into wiring an ezboil DSPR 320 for just a heating element and on 240V with no neutral. I'm pretty lo-fi, I don't have any pumps and don't maintain perfect temperature when mashing. (Does anyone else do just a heating element with...