Recent content by Boggs6ft7

It was the 177 rpm motor from Surplus Center that a lot guys on the board have used. I don't think it is still available though.

Thanks. More than once I was wondering why I was spending time (and money) on making this out of poplar. But I'm happy with the final results.

I have been working on this off and on for the past few weeks. I've had the motor since spring time, but I have been putting off this project. My goal was a mission style table make of mortise and tenons. What I did not expect was the number of bar clamps I would need. So it is slightly...

I'm in.

I'm running at 177 RPM's. I got that motor from Surplus Center that a lot of guys have been using.

Because it can only be bolted from one side.

I want to have a more table space not taken up by a motor since it will be underneath as well. As for the link, I don't want to do a belt driven system. I already have a motor to direct drive the crusher.

First post, long time lurker though. My question is if I can take a Barley Crusher and flip it over to mount it underneath a table. I want to motorize using a direct drive motor, but I would like to mount everything under the surface to give a little more table space. I realize I will...