Recent content by BLUEZL600EFI

There is a learning curve to using it, you must keep the stopper on tight to create a airlock in the bottle to allow it to fill slowly. Then you very lightly vent the stopper in little "pssttttts" to allow the bottle to continue filling.

Then yes I make them for you, see my website. However I am out of stock right now, they are scheduled to be run later next week.

:drunk: That could be, my bad. Had a bad day at work today and have been hitting the home brew a little hard. If the push in ones work out for everyone I would most likely not pursue any other options.

Already do. http://centerlinemachining.com/homebrew.htm

With all the chatter on the new 525 bottle filler I thought I would post this to let everyone know that I make the fillers for the threaded taps. For both Perlick and Ventmatic taps. I also make the threaded 8mm spouts to eliminate the hollow pour that you get with the stock side spouts...

I saw that. However he is not selling them, that I can find. And I am not convinced that it would not blow out when counterfilling, there is quite a bit of back pressure when filling up a case of bottles. For one or two you could hold it in, but I sometimes bottle 4-5 gallons at a time that...

I am currently working on a bottle filler for the Perlick 525 tap. I have a couple ideas and would like some feedback to see what the interest would be. The first is how is everyone liking the pour from these things stock? Any hollow pour issues like the old stock 425's? Second is I am...

Try again I cleared my inbox, got an email saying I was full. I have not made anything for the 525, I don't even have time to machine another run of the regular ones I have been so busy at work.

I am working on a bottle filler kit that will work on the new 525 Perlick (solid piece units). I may also have a kit for the standard non forward sealing taps as well. I will post here if and when they become avaiable. Also as I reminder I do have these with the Ventmatic thread as well.

Hello I'm Mike the guy who owns Center Line. I should have these on the website later this week. I only made a handful (both thread sizes). I will make more but not for a few weeks as my supplier is out of food grade stainless. I will sell the few I have on a first requested first served. You...