Recent content by AuTrappiste

Hello all, I picked up a 30 Gallon tank with a 1.5 inch Tri clamp curved port on the bottom of it. I wanted to use a jet burner to heat the kettle which generates significant heat. Silicon gaskets are rated to 400 degrees continuous duty. I would run a tri-clamp connection with straight...

Thanks for the help! I just ordered the bulk of my parts from Auberins. Looking forward to getting the parts.

Awesome - Thanks for the help JayMac. One other question. When mashing do you just leave the valve from the mash tun to the pump & RIMS tube open so the PID will control things without monitoring. I assume this is what must be done unless one were to get an automated value.

Thanks for all of the information and pictures in the post. I am going to order my parts this week. One quick area of clarification. I am new to complex electrical diagrams so I will lean on a friend to help put this together. However I did have a question. From what I can tell I need...

Just sent a PM - Please check it out.