Hi, this is my first posst, and I will introduce myself formally, but i'm hoping someone can help me out quickly. I have a small Danby Kegerator, that I am pretty sure the starter relay went bad on. When plugged in, i can feel the compressor has power, but after a few seconds, the overload kicks. The relay looks to have some meltage, so for $12 i figured it was worth a shot.
Anyhow, the relay part number is 644.33B, apparently it is not in stock and it will be 10-14 to get it. it is a pus hon type, with 2 holes to attach, and one wire attaches to it from the plug, the other wire attaches to the overload, which is a separate piece, both plug into the 3 prongs on the compressor.
Is there another relay i could use? i can crimp/make a connector if need be, but would like one that just plugs in if possible. I really dont know anything(yet) about refrigerators and compressors, however i am extremely mechanically inclined, have built motorcycles from the ground up, and can wire up a circuit board, if given enough information.
Help? i have a couple bags of ice in the kegerator trying to keep the beer cold!
Anyhow, the relay part number is 644.33B, apparently it is not in stock and it will be 10-14 to get it. it is a pus hon type, with 2 holes to attach, and one wire attaches to it from the plug, the other wire attaches to the overload, which is a separate piece, both plug into the 3 prongs on the compressor.
Is there another relay i could use? i can crimp/make a connector if need be, but would like one that just plugs in if possible. I really dont know anything(yet) about refrigerators and compressors, however i am extremely mechanically inclined, have built motorcycles from the ground up, and can wire up a circuit board, if given enough information.
Help? i have a couple bags of ice in the kegerator trying to keep the beer cold!