Boerderij_Kabouter
Well-Known Member
I am trying to wire up an RTD to a PID from Auber Instruments. RTDs use three wires. This one has two red and one white. I know I need to keep the wiring consistent through the connectors and that parts ois right.
RTD:
http://www.auberins.com/index.php?main_page=product_info&cPath=15&products_id=84
PID:
http://www.auberins.com/index.php?main_page=product_info&cPath=1&products_id=106
And here is the wiring diagram for the PID:
HELP!
Note: The connector supplied by Auber has the two reds leads soldered together. Is that right? Maybe I need to seperate those and it would work>???
Right now, it reads about 40º too high. Ambient is about 68º and it is reading 121º.
Thanks in advance!!
-Justin
RTD:
http://www.auberins.com/index.php?main_page=product_info&cPath=15&products_id=84
PID:
http://www.auberins.com/index.php?main_page=product_info&cPath=1&products_id=106
And here is the wiring diagram for the PID:
HELP!
Note: The connector supplied by Auber has the two reds leads soldered together. Is that right? Maybe I need to seperate those and it would work>???
Right now, it reads about 40º too high. Ambient is about 68º and it is reading 121º.
Thanks in advance!!
-Justin