Vendor to drill/tap a triclover cap?

[chuckjaxfl]

Do any board vendors/members take on one-off custom work. I'd like to have a tri-clove cap drilled and threaded, exactly as this one:

https://www.homebrewtalk.com/f170/tri-clamp-heatsticks-287978/#post3586570

I'd rather give the work to board folk and just mail the part than hunt down a local shop.

 

[thelorax121]

Send Swagman a PM and he will be able to whip up any kind of TC fitting you can dream up for as cheap as you can find anywhere. I can vouch for his work, as I have a few sets of tir-npt/nps fittings as well as an all TC RIMS tube he fabbed for a song....

 

[wyzazz]

Swagman unfortunately isn't on this board anymore. Try a local machine shop, that's who did mine. It cost me $10.00 and I brought the guy a sixer of homebrew. He said the next one was on him.