M25
Member
I'm planning an E-HERMS build in the future based on the electricbrewery design. It will be a build allowing for 10 gallon batches, but I would like to do either 5 or 10 gal batches. I'm concerned that the mash tun selection for a 10 gallon batch will not give appropriate grain bed depth for a 5 gallon batch. I'd like to hear some opinions on this. I'm preferring using kettles over keggles. Also considering stout tanks as a potential supplier. Should grain depth be a concern at these volumes?
note: 10/5 gallon batch meaning in keg. typical 5 gal batch is about 14# of grain.
Thank you for your opinions!
note: 10/5 gallon batch meaning in keg. typical 5 gal batch is about 14# of grain.
Thank you for your opinions!