Hi all,
Just finished my yearly(-ish) teardown and deep cleaning of my corny kegs, and ran into a small issue.
For one keg (which is in otherwise great condition), I've got a super tiny "leak" on the gas post. All o-rings have been replaced, and I lightly lubed up each o-ring on the gas side as I rebuilt the post.
The keg is holding pressure without any problem, but I've noticed that as soon as I remove the disconnect from my CO2 tank, there is a super tiny leak from the poppet surface on the gas post. This lasts for ~2 seconds, and stops as soon as my finger touches it. It doesn't appear to be a problem, but just more of a small frustration after an afternoon of work
Any thoughts / suggestions would be greatly appreciated!
Just finished my yearly(-ish) teardown and deep cleaning of my corny kegs, and ran into a small issue.
For one keg (which is in otherwise great condition), I've got a super tiny "leak" on the gas post. All o-rings have been replaced, and I lightly lubed up each o-ring on the gas side as I rebuilt the post.
The keg is holding pressure without any problem, but I've noticed that as soon as I remove the disconnect from my CO2 tank, there is a super tiny leak from the poppet surface on the gas post. This lasts for ~2 seconds, and stops as soon as my finger touches it. It doesn't appear to be a problem, but just more of a small frustration after an afternoon of work
Any thoughts / suggestions would be greatly appreciated!