TuttleCreekBrewing
Well-Known Member
So after far too long browsing this forum, and too much frustration with bottling, I've decided it's time to start kegging. And of COURSE if I'm going to be kegging, I have to have a keezer to go with it! And of COURSE if I'm going to build a keezer, it's going to be K-State! :rockin:
I think I have it all planned out, but I welcome all suggestions, questions, and advice! It will be placed in the living room and will displace an existing chair, so I wanted to have the top extend out to create a bar and stick a couple of bar stools under it so that I'm not losing any seating. To compensate for the weight, I want to do the top in vinyl tile instead of ceramic.
For the freezer, I'm using the popular GE 7.0 FCM7SUWW, which from my research should fit 3 ball locks without a collar, or 4 squeezed in tightly.
What do you all think? The freezer should be delivered 11/9, so any suggestions or comments before I start cutting would be very appreciated!
I think I have it all planned out, but I welcome all suggestions, questions, and advice! It will be placed in the living room and will displace an existing chair, so I wanted to have the top extend out to create a bar and stick a couple of bar stools under it so that I'm not losing any seating. To compensate for the weight, I want to do the top in vinyl tile instead of ceramic.
For the freezer, I'm using the popular GE 7.0 FCM7SUWW, which from my research should fit 3 ball locks without a collar, or 4 squeezed in tightly.
What do you all think? The freezer should be delivered 11/9, so any suggestions or comments before I start cutting would be very appreciated!