I'm trying to figure out the correct placement for a temperature probe on my Therminator plate chiller. Unfortunately, the in/out ports are placed rather strangely and make it difficult to position the chiller itself for easy connecting/disconnecting in/out hoses as well as a temp probe on the "wort out" port. I placed an elbow so that I could see the temp probe's face in it's current position, but this adds some additional piping that the wort has to flow into to fill. I'm not sure if this will give the most exact readings.
Here's a pic (it's not all screwed in tight yet, I was prototyping)
What do you guys think? Would this work or would it skew my readings? The probe is 2" btw.
Here's a pic (it's not all screwed in tight yet, I was prototyping)
What do you guys think? Would this work or would it skew my readings? The probe is 2" btw.