Temp probe location on my 1st keezer?

[VegasBrew1]

Howdy brewers. I've been using mini fridges as ferm chambers. I have a bungee cord around each bucket, insulate the stc-1000 prob by carving a small notch out of some thick/dense foam. The bare part of the probe goes against the bucket, the foam part protects from ambient air readings. I was gonna do the same for my keezer temp controller, unless experienced guys caution against it or have better ideas. What say you?

Thanks, and carry on.

 

[iijakii]

That's a good method and carries over as well. I just pick a keg and tape the probe to it.