Hey All,
I currently do all electric BIAB recirc using RIMS. I have a weldless bulkhead that I put in my lid for the recirc during the mash, what is everyone using for a spray type head attached to the inside of the bulkhead.
I've found that if I just do a steady stream I end up with massive foam inside the kettle but if I had a spray head it would distribute the wort evenly and keep that knocked down. I heard people use spray heads but not sure what or where I would get one of these without building it from scratch.
I did consider using a long pick-up tube attached to the bulkhead that would reach down to below the wort level which should also keep the foam down as an alternative.
Thanks for any help, brewing tomorrow and finishing up a few last minute modifications.
RP
I currently do all electric BIAB recirc using RIMS. I have a weldless bulkhead that I put in my lid for the recirc during the mash, what is everyone using for a spray type head attached to the inside of the bulkhead.
I've found that if I just do a steady stream I end up with massive foam inside the kettle but if I had a spray head it would distribute the wort evenly and keep that knocked down. I heard people use spray heads but not sure what or where I would get one of these without building it from scratch.
I did consider using a long pick-up tube attached to the bulkhead that would reach down to below the wort level which should also keep the foam down as an alternative.
Thanks for any help, brewing tomorrow and finishing up a few last minute modifications.
RP