Robobrew v3 question

[Rev2010]

I gave mine a test today using water. Everything went perfectly. One thing I noticed though is some temp ranges allow for one degree changes and others only allow you to jump two degrees. I can't recall exact numbers but an example would be I can do 147 then go one up to 148 but when I try to go from 154 to 155 it goes to 156, I can't select a set temp of 155. This normal?


Rev.

 

[Rev2010]

No Robobrew users to confirm this?

 

[agrummett]

I don’t have this issue using Celsius

 

[Rev2010]

I don’t have this issue using Celsius

Yeah, I figured it's because it's designed for Celsius and is actually just converting Fahrenheit to Celsius hence why it can't do each Fahrenheit step precisely.

Rev.

 

[SpottedDogBrewing]

I just had this problem today or just noticed it. But it seemed it was only going up by even digits and then it went up by single digits. Not sure whats the deal. I tried searching and haven't found anything about it

 

[RePete]

In Fahrenheit mine sets in 2 degree increments.