Reverse Polarity Brewery - Kal Clone

[milldoggy]

Followed kals box design. I actually put the cover on backwards, so I pounded down the edges, but other than that, it is the same

 

[duckdogs]

Nice Syste,m!

Be careful putting 90 degree elbows on the inlet side ...this may cause restriction of flow to the pumps ...always plumb inlet side with the least restriction possible ..in order to avoid cavitation

MIKE

Just open the valve for a count of Oo idk 10 seconds and turn the pump on..or until you can see the fluid going threw the pump it looks like you are using silicone hose easy to see threw.

 

[milldoggy]

I took off the 90s on the inlet and rotated the head. Worked much better

 

[milldoggy]

well, we moved last year. Been spending the last 11 months remodeling. Entire first floor and a lot of the second. Pretty much done, so it is on to setting up the brewery. Spent the last week rerunning plumbing. Got the water and sewer done. Just need to install the vent for the pump. Moved some of the outlets. Hung the hood. Had to patch the existing vent hole and cut a new 6 in hole. Here is where I am at. Found an amazing sink, thing is huge.

 

[milldoggy]

Wrong pic attached

 

[milldoggy]

First brew done