JVD_X
Well-Known Member
Hi Folks,
I was wondering if anyone knew how to solve this problem. I recently built a mashtun with a copper manifold. The problem is that after cutting the slots (BTW - should have used my dremel instead of a saw) there is a bunch of jagged copper left on the inside of the pipe I can't get to.
Does anyone have any idea how I could clean out the inside of the pipe? I don't want bits of copper getting into my beer!
I was wondering if anyone knew how to solve this problem. I recently built a mashtun with a copper manifold. The problem is that after cutting the slots (BTW - should have used my dremel instead of a saw) there is a bunch of jagged copper left on the inside of the pipe I can't get to.
Does anyone have any idea how I could clean out the inside of the pipe? I don't want bits of copper getting into my beer!