Was thinking about recirculating with my BIAB setup. Have a stainless head march pump. Do I throttle that on the output or input side? Full flow seems like too much. Need to knock it down some.
I just bought one of those tiny little pumps off Amazon for this very thing. I guess I am going to need to put a hole in my kettle lid? Also, what kind of sprayer/head do I put on the inside?
Was thinking about recirculating with my BIAB setup. Have a stainless head march pump. Do I throttle that on the output or input side? Full flow seems like too much. Need to knock it down some.
I just bought one of those tiny little pumps off Amazon for this very thing. I guess I am going to need to put a hole in my kettle lid? Also, what kind of sprayer/head do I put on the inside?
No need to go through the lid. I simply use a shop clamp to hold my tee to the kettle and run a hose down to the mash. I found having the return through the lid to be cumbersome. This will be true for you too if you use an immersion chiller. But even when I use my plate chiller I always seem to have a reason to run the pump without the lid on.
so you don't loose too much heat this way?
I just bought one of those tiny little pumps off Amazon for this very thing. I guess I am going to need to put a hole in my kettle lid? Also, what kind of sprayer/head do I put on the inside?
mind sharing link to pump and how does it work?
If you are recirculating and believe in hot side aeration, don't spray, just return to the top of the grain bed without splashing.
Enter your email address to join: