dhollandcpa
Member
- Joined
- Aug 5, 2013
- Messages
- 9
- Reaction score
- 0
Hello,
I recently upgraded to a 5 lb. CO2 tank and taprite regulator, so I wanted to pass along my pinvalve setup to someone who will use them.
I have two 20oz. CO2 tanks (totalling 2.5 lbs), both are hydro tested until 2018. Also have the regulator with pinvalve fittings. The paper in the backside of the regulator is bent and thus wont read higher than around 16 psi. I've never bothered with it because its not really necessary for our purpose but if you wanted it to read higher you can get a replacement gauge for 10-15 bucks at Amazon, eBay, etc.
Here is additional detail for the regulator:
http://www.kegconnection.com/pin-valve-regulator-single-guage-5-16-check-valve/
Everything works great.
The reg is $58 new and bottles around $18 each new. Asking $65 for everything plus $5 for shipment. If you're in central New York we can arrange a drop off.
I recently upgraded to a 5 lb. CO2 tank and taprite regulator, so I wanted to pass along my pinvalve setup to someone who will use them.
I have two 20oz. CO2 tanks (totalling 2.5 lbs), both are hydro tested until 2018. Also have the regulator with pinvalve fittings. The paper in the backside of the regulator is bent and thus wont read higher than around 16 psi. I've never bothered with it because its not really necessary for our purpose but if you wanted it to read higher you can get a replacement gauge for 10-15 bucks at Amazon, eBay, etc.
Here is additional detail for the regulator:
http://www.kegconnection.com/pin-valve-regulator-single-guage-5-16-check-valve/
Everything works great.
The reg is $58 new and bottles around $18 each new. Asking $65 for everything plus $5 for shipment. If you're in central New York we can arrange a drop off.
