Liveforliving
Well-Known Member
- Joined
- Aug 3, 2014
- Messages
- 59
- Reaction score
- 2
So, I'm about 1/2 through wiring up the new electric brewery. I'm working on the PID, which is a TA4-SSR.
I have Auber RTD Probes and will be attaching one to each of my 3 PIDs. Looking at the diagram (attached), I need to wire my lone white wire to 7, and my two red wires to 8 & 9 (doesn't matter which one). There seemed to be mixed information on the forums if a jumper is put for 7 & 10. Can someone confirm all this?
I have Auber RTD Probes and will be attaching one to each of my 3 PIDs. Looking at the diagram (attached), I need to wire my lone white wire to 7, and my two red wires to 8 & 9 (doesn't matter which one). There seemed to be mixed information on the forums if a jumper is put for 7 & 10. Can someone confirm all this?
