twd000
Well-Known Member
I bought two 110V STC-1000 controllers off eBay for my side-by-side fridge conversion. I got them wired into a box and turned it on. The default values are left as-is, so there is a 3 minute compressor delay where the cooling light blinks. After the delay, I hear the relay snap, the red light stays on and...nothing. I get no power to the switched outlet I wired to Unit #1, nor the bare leads I wired to Unit #2. I tried plugging in various electrical devices, fans, etc just to see if it would run them (haven't plugged in fridge yet).
The directions and sticker on the controller say 11V supply, 220V output (wouldn't that be impossible?). But I opened the box and the Zettler magnetics sticker clearly lists 115V@60kHz AC.
So I'm confused. Should I expect my multimeter to read 100V across the output side once the red cooling light on on? I'm not getting any reading.
The directions and sticker on the controller say 11V supply, 220V output (wouldn't that be impossible?). But I opened the box and the Zettler magnetics sticker clearly lists 115V@60kHz AC.
So I'm confused. Should I expect my multimeter to read 100V across the output side once the red cooling light on on? I'm not getting any reading.