New brewtroller power box

[heapyjeepy]

Started working on the new setup after my brewtroller and remaining projects were completed. Here are some picks of the control box so far. I'm running a direct fire system and using a custom made circuit with 4 electric ball valves.

 

[heapyjeepy]

I recently tested out the power supply and found a nice way to hold up my main power board. The power supply makes a bit of a high frequency sound but I assume it's because of the fact there isn't any load on it aside from the fan. Fan started up fine tho.

Next complete the wiring for the dual fans. Then start wiring the brewtroller to the IC.

 

[heapyjeepy]

I also needed a better way of knowing how to wire my IC. So I took a picture of the top and the bottom of the IC and overlaid them with a bit of transparency one the top one. After mirroring the top of course.


Bottom





Top (not mirrored)





Overlaid





I also started labeling the picture of the overlay and can reference it on my new IPad while wiring it up.