- Joined
- Nov 18, 2008
- Messages
- 2,058
- Reaction score
- 25
I bought some 1/2" SS tubing on ebay. I'd like to make some pickup tubes, and a hex coil. In a few places I'd like to make a fairly tight radius.
Here is what I have:
1/2" O.D. (.020 wall) 304/304L Stainless Steel beverage grade tubing
# Bright Annealed
# Tensile Strength PSI: 87738
# Yield Strength PSI: 43749
# % Elongation: 50
# Hardness: B-75.5
# Spec: ASTM-A269-08/A249/A249M-08/ASME-SA249/SA249M-07
I've played with it a bit and not very happy with the results so far. Any advice would be appreciated.
Thanks,
Ed
Here is what I have:
1/2" O.D. (.020 wall) 304/304L Stainless Steel beverage grade tubing
# Bright Annealed
# Tensile Strength PSI: 87738
# Yield Strength PSI: 43749
# % Elongation: 50
# Hardness: B-75.5
# Spec: ASTM-A269-08/A249/A249M-08/ASME-SA249/SA249M-07
I've played with it a bit and not very happy with the results so far. Any advice would be appreciated.
Thanks,
Ed