My 3D Printable Stirplate

[walther]

Here is my 3D printable stirplate:
http://www.thingiverse.com/thing:1114571

Only requires a fan, some magnets, and a 3D printer

 

[NeoBrew]

That is awesome!

What did you use for speed control?

 

[walther]

Thanks,

I just just used a small PC fan controller.
There is a hole in the back where I can reach it with a screwdriver.



http://www.aliexpress.com/item/12V-...1644_4_79_78_77_82_80_62_81,searchweb201560_1

 

[Turkeyshot]

Which make and model 3d printer are you using?

 

[walther]

I'm using a MendelMax 1.5, with an E3D-V6 head:

http://www.thingiverse.com/thing:1003968

 

[Turkeyshot]

Cool, thanks. I have been looking at different models, so I will check that one out too!

 

[WPStrassburg]

Nice work. Interested in doing any of the magnet holders for a few bucks?

 

[walther]

@Strassburg, I live in Denmark, so you may know someone with a printer closer by
Otherwise, drop me a pm.

 

[thehebs]

Thanks for this. How are you powering the fan? What size screws?