Please visit and share your knowledge at our sister communities:

Cheesemaking Forum Cast Iron Forum Canning Forum Ceramic Grills

Espresso Forum Hot Pepper Forums Pizza Oven Forums
If you have not, please join our official Homebrewing Facebook Group!

Homebrewing Facebook Group

Multi-Jet Burner Problem

Thread starter ZooBrewer
Start date Jul 26, 2015

Help Support Homebrew Talk:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

ZooBrewer

Member

Jul 26, 2015

I just completed a Brutus 10 build. Everything is near identical to Lonnie McAllister's design, including the gas valves. I'm using the H212, low psi, 92,000 BTU multi-jet burner. I created and mounted my own pilot using 1/4" black pipe, capped with a 1/16" hole drilled. The pilot works well. My problem: The pilot lights a jet or two. The rest of the jets don't ignite. There is fuel flowing through the jets as I can ignite each jet with a lighter. I think it is a matter of how much fuel is flowing to the burner. I played with the manual valve, but didn't have much luck. Any suggestions?