I have a new to me sanyo minifridge kegerator. My current setup is with an Inkbird 308 set to 38*f with a 3*f differential. The temperature probe is taped to a 1L seltzer bottle covered by about 3 in of foam on that side...sitting next to the co2 tank on the compressor hump (probe facing the door).
I also have a remote air temperature sensor midway in height on the side of the cabinet. I just put a 120 mm muffin fan sitting on top of one of the keg's to circulate the air because i noticed via the air temp it would get up to 50*f before the inkbird would kick on.
Now that muffin fan has helped keep the air temperature from getting up so high, but now the fridge is pretty much on all the time. It'll run for an hour, then off for an hour, then back on. Previously it would run for an hour, stay off for 2-3 hours, and then repeat.
Obviously this is due to the more constant air temp in the fridge, but is there anything I can do to lengthen the cycle...seems like turning on every hour for an hour is to much cycling.
I also have a remote air temperature sensor midway in height on the side of the cabinet. I just put a 120 mm muffin fan sitting on top of one of the keg's to circulate the air because i noticed via the air temp it would get up to 50*f before the inkbird would kick on.
Now that muffin fan has helped keep the air temperature from getting up so high, but now the fridge is pretty much on all the time. It'll run for an hour, then off for an hour, then back on. Previously it would run for an hour, stay off for 2-3 hours, and then repeat.
Obviously this is due to the more constant air temp in the fridge, but is there anything I can do to lengthen the cycle...seems like turning on every hour for an hour is to much cycling.