mash PID settings

[inda_bebe]

Yeah, K type probes are WAY different than RTDs. That would explain a lot of your issues. But still - you need to read the manual and the advice on theelectricbrewery.com and run the auto-tune from start to finish - once you get the right wires / RTD probe...

I adjusted everything back to default settings and it ran good within 5 degrees. I adjusted the Pb to calibrate it to match my glass thermometer. The customer service guy said that I didn't need to run auto tune because it has fuzzy logic. I'm going to run it regardless. Thanks for all your feed back

 

[theknub]

glad it's 'working'

an autotune will certainly help and get the differential set right and you'll be fine.

 

[jeffmeh]

I adjusted everything back to default settings and it ran good within 5 degrees. I adjusted the Pb to calibrate it to match my glass thermometer. The customer service guy said that I didn't need to run auto tune because it has fuzzy logic. I'm going to run it regardless. Thanks for all your feed back

According to the owner of Auber, there is no "learning" except in autotune mode, fuzzy logic or otherwise.