Leaky keg again...

[masonsjax]

On all of my kegs the gas posts have little notches, or an engraved ring around the points of the bolt part to differentiate them.

Back to the leak, I don't remember if you replaced the orings or said they look ok. If you haven't, just replace them. The are cheap. Check the wiki for mcmaster part numbers.

 

[Homercidal]

AH. Actually, I think I once hooked the wrong QDs to the wrong posts. I wonder if I accidentally damaged the QD. It was a bit of a struggle to get it off the post. I forgot about that until I read the last few posts here.

 

[masonsjax]

Actually, on most of my kegs, I have been able to put the gas disconnect on the liquid post and remove it easily. My first few batches I was so anxious to tap them that I force carbed through the liquid post. I'll have to look and see if they're actually different on all of my kegs.