MrBulldogg
Well-Known Member
I found myself having a bit of a problem with the bottling bucket in that while the bucket is round, the plastic spigot seems to be made for a flat surface. As a result, no matter how much I tighten it (yes, rubber washers on both sides) there is a small but annoying drip whenever the bucket is more than half-full.
It's from a TrueBrew starter kit so I imagine I can't be alone in having experienced this annoying issue. How should I/did you fix it? Or do I have to bite the bullet and buy a new bucket/spigot?
It's from a TrueBrew starter kit so I imagine I can't be alone in having experienced this annoying issue. How should I/did you fix it? Or do I have to bite the bullet and buy a new bucket/spigot?