Using a new edgestar kegerator, first brew in a keg. Have had the keg in the fridge at about 40 degrees for 2 weeks. Pressure was set at 15 psi before refrigeration.
Today I pressured the keg to 12 psi. Hooked up the beer line. Was hoping for a frosty mug of homebrew…. Instead got about 10 pints of foam. No fluid is coming out only suds.
Backed the pressure down down to 2, gradually built up to 10-12. No change in foam except more spitting.
Disconnected everything to make sure I wasn’t missing something.
Everything seems correct.
Beer hose is original, probably 5’
Beer hose is all bubbles, no liquid appears to be flowing.
On top of that, beer somehow got up into the gas line too.
Needless to say I am puzzled. Any suggestions on where to start?
Thanks
Today I pressured the keg to 12 psi. Hooked up the beer line. Was hoping for a frosty mug of homebrew…. Instead got about 10 pints of foam. No fluid is coming out only suds.
Backed the pressure down down to 2, gradually built up to 10-12. No change in foam except more spitting.
Disconnected everything to make sure I wasn’t missing something.
Everything seems correct.
Beer hose is original, probably 5’
Beer hose is all bubbles, no liquid appears to be flowing.
On top of that, beer somehow got up into the gas line too.
Needless to say I am puzzled. Any suggestions on where to start?
Thanks