Don I have the same one you got. I looked at the pics and got spooked for a min b/c my door cut outs are almost identical to yours! I got a twin tap tower custom homebrew kit from beveragefactory.com, seems to be the way a lot of folks are going with this.Cheers!
Does your model have supports for the shelves that plug into brackets along the back or does it use molded supports on the sides of the fridge? I bought the one from Costco and it has the molded supports which I had to cut out in order to fit two corny kegs.
I posted some pics here: Danby DAR044
I haven't picked out my tower yet so I'm just using picnic taps for now.
Don
Thx for the info -- will go all the way up to 1/4" hole tomorrow and complete the project (fixing leaky MLT has taken project time priority the last few weeks)I used a 1/4" drill bit, they fit though without an issue. I didn't bother with a support on the inside, it holds just fine.