Scottiamit
Member
- Joined
- May 15, 2016
- Messages
- 8
- Reaction score
- 5
Hi guys I have a new keezer setup and I am getting too much head on my first pour and almost nothing on my second pour (back to back). I have used a few calculators for line length but seem to get different results in each and I am not 100% sure that is the issue if my second pour has little head? The top of my keg is actually slightly higher than my taps (about 50mm) and I am using 2 metres of beer line (approx 5mm inner) coiled up and my co2 is sitting at 10PSI atm. The keg has had plenty of time to settle as it has been in there about 3 weeks. Below is a photo of 2 pours done one after the other showing the issue. Any ideas on how to resolve? Thanks.