Just posting to Thank You guys for these Ideas!! Grain Mill and Hop Spyder!

mrrrkva · Nov 28, 2011

Ran into a few bumps with my grain mill, but Finally it is done!! I couldnt get enough tension on the belt, so I built my own DIY belt tensioner!! And the Hop spider is using your ideas and BYO's DIY project. Also, thank you for the idea to insulate my MLT

:mug:

bad67z · Nov 28, 2011

Very nice work, about to start on a similar grain mill project.

krenshaw · Nov 29, 2011

how is the motor holding at that angle?

bad67z · Nov 29, 2011

krenshaw said:
how is the motor holding at that angle?

It looks to me like he used the weight of the motor to apply the tension to the belt.

dfess1 · Nov 29, 2011

looks good. I'd look into getting a link belt for the grain mill (can get them at woodworking stores), so your belt doesn't "take a set".

mrrrkva · Nov 29, 2011

Thanks for the complements. Bad67z said it correctly, the weight of the motor keeps tension on the motor... When its not in use, I just "flip" the motor up so there is no tension on the belt to deform it. But I am open to suggestions. Without the weight of the motor, I would go thru 10-12 lbs of grain and the belt would slacken up.... and I would have to readjust the motor... this way it will go thru countless pounds. Thanks Dfess1, I will check into those.