So I Just bought 2 ball lock kegs, in and out connectors, and a slightly used reg.
I want to make everything pretty lol I know to fill the keg with oxiclean and let them soak for a while and then run water through them a few times. That should clean the beer out connector too. How can I clean the outside to get all the gunk off and make it shiny? I like thinks to look nice even if they aren't being seen. I am OCD like that.
All this equipment was used for soda and I don't think it has been cleaned since the last use.
Also, what would you replace? Would you replace just the o-rings or everything the two posts, dip tubes, pressure release valve?
I want to make everything pretty lol I know to fill the keg with oxiclean and let them soak for a while and then run water through them a few times. That should clean the beer out connector too. How can I clean the outside to get all the gunk off and make it shiny? I like thinks to look nice even if they aren't being seen. I am OCD like that.
All this equipment was used for soda and I don't think it has been cleaned since the last use.
Also, what would you replace? Would you replace just the o-rings or everything the two posts, dip tubes, pressure release valve?