Using the iDip system, my water came back as:
Results
Test Name: Sodium
Test Result: 4 ppm
Test Name: Residual Alkalinity as CaCO3
Test Result: 17 ppm
Test Name: Magnesium Hardness MG
Test Result: 21 ppm
Test Name: Sulfate
Test Result: 1 ppm
Test Name: Hardness, Total (as CaCO3)
Test Result: 21 ppm
Test Name: Chloride
Test Result: 13 ppm
Test Name: Calcium Hardness (as CaCO3)
Test Result: 0 ppm
Test Name: Alkalinity, Total AL
Test Result: 20 ppm
Question is, I can't figure out how to plug these numbers into Brun Water correctly as my test does not have Bicarbonate. Also I am not sure if my other perimeters are entered correctly as it does not say if they are CaCO3. Apologies in advance for bugging, just really would like to figure this out and so far this spreadsheet is frustrating..
I have Beersmith and do like to adjust my PH with Phosphoric Acid so would like to use Bru'n Water in addition to Beersmith....
Thanks in advance...
Results
Test Name: Sodium
Test Result: 4 ppm
Test Name: Residual Alkalinity as CaCO3
Test Result: 17 ppm
Test Name: Magnesium Hardness MG
Test Result: 21 ppm
Test Name: Sulfate
Test Result: 1 ppm
Test Name: Hardness, Total (as CaCO3)
Test Result: 21 ppm
Test Name: Chloride
Test Result: 13 ppm
Test Name: Calcium Hardness (as CaCO3)
Test Result: 0 ppm
Test Name: Alkalinity, Total AL
Test Result: 20 ppm
Question is, I can't figure out how to plug these numbers into Brun Water correctly as my test does not have Bicarbonate. Also I am not sure if my other perimeters are entered correctly as it does not say if they are CaCO3. Apologies in advance for bugging, just really would like to figure this out and so far this spreadsheet is frustrating..
I have Beersmith and do like to adjust my PH with Phosphoric Acid so would like to use Bru'n Water in addition to Beersmith....
Thanks in advance...