Well, my SWMBO told me that I had to start being able to drink the beer that I was kegging and therefore needed to build a Keezer.
I, after much deliberating, bought a 14.8 Maytag MQC1552TEW, which will hold 10 ball locks on the floor, a 5# tank on the hump, and doesn't need a collar to do it.
No, combine the fact that it doesn't need a collar with my design choice- through the wall taps to a small bar in the living room- you might start to see where I'm coming up against keezer-builder's block. My perlicks are here, along with nearly everything else (no tail pieces...), but I don't know what the best way to handle this is.
I've thought of drilling the freezer, but the lines travel in the walls, and I'd hate to pierce one.
I can't think of a way to bring the lines up out through the lid without either A) losing the ability to open it or B) having the lines exposed (both visually and uninsulated).
Doing a coffin build doesn't work ("Too much geometric solid in the living room, No!" says the architect SWMBO)
So.. Yeah- Suggestions?
I, after much deliberating, bought a 14.8 Maytag MQC1552TEW, which will hold 10 ball locks on the floor, a 5# tank on the hump, and doesn't need a collar to do it.
No, combine the fact that it doesn't need a collar with my design choice- through the wall taps to a small bar in the living room- you might start to see where I'm coming up against keezer-builder's block. My perlicks are here, along with nearly everything else (no tail pieces...), but I don't know what the best way to handle this is.
I've thought of drilling the freezer, but the lines travel in the walls, and I'd hate to pierce one.
I can't think of a way to bring the lines up out through the lid without either A) losing the ability to open it or B) having the lines exposed (both visually and uninsulated).
Doing a coffin build doesn't work ("Too much geometric solid in the living room, No!" says the architect SWMBO)
So.. Yeah- Suggestions?