thanks-
Last edited:
Thats the point. I have a blank to drill. I can't fit the coil inside. wondering if the temp twister I have can be modified to fit or if there are any narrower options to fit inside. I would prefer a nice clean look and have glycol running inside.While I agree with the above it's all moot unless the OP can figure out how to get that coil inside the fermenter....
Cheers!
I think either the FLEX temp control coil or one of the CF series temp control coils should fit. I thought I saw the lengths listed somewhere but you could always ask Spike directly.Thats the point. I have a blank to drill. I can't fit the coil inside. wondering if the temp twister I have can be modified to fit or if there are any narrower options to fit inside. I would prefer a nice clean look and have glycol running inside.
I'll check with spike to see if they do that.Finding someone to weld a fitting in would be ideal but those weldless fittings work great but not sure what type of pressure they'll hold. Perhaps Spike can weld a fitting into that temp coil TC for your CO2 release. I know Spike can customize their fermenters like they do for their kettles.
Im not sure if spike has a coil without the cap attached. If so , you can get a blank and drill it for duotight bulkhead fittings. Or cut this one and drill out. I measured the coil section and its 12”. Could be compressed a little shorterMay have to look into this now. My problem is my kegmentrr is a standard 1/4 barrel size so it only 12.5inch from top opening to bottom. May still work though gonna take some measurements. Do you think the coils could be compressed a little to make it slightly shorter ?
Enter your email address to join: