I have decided to sell my panel, I built it a cpl years ago but have not used it. Life got in the way and it has sat since. It has been tested but I haven't ran any batches with it. It's housed in a 24x16 Custom powder coated Hoffman enclosure with a stainless door. Everything is on din rails and I used wire duct. Breakout boards were used to eliminate the loose wires to the door and it is fed by a Hubbell pin and sleeve connector, which I have both pieces to. All pids are Auber and it features a switch to go between PID and their rotary controller for the boil. Each vessel has its own alarm and also a separate pid for the Hex. You can use either a Rims or a Herms setup with this. It is wired for 3 pumps @220 but could easily be changed to 110. I'm looking to get $2500 for the panel and temp sensors. I believe I have 3 triclover probes. (Possibly more). I also have 3 keggles and a 1/6 bbl that I was going to use for the separate herms. They are all bottom drain and have all welded stainless fittings. This will be avail for an additional 500 to the buyer I have a pile of stainless fittings etc that will go with if that's the case. I also have 11 ball lock kegs that will be avail should the panel sell. Located in the UP of MI and pickup would be best I think.