Telemachus
Member
- Joined
- Apr 26, 2020
- Messages
- 5
- Reaction score
- 0
I'm hoping to drill a hole in the back of this, not for a shank, but for feed and output lines from a cold plate for my under counter soda setup.
Other than the alcohol and cornstarch method, I'm thinking I will just probe around in the foam in the back and make sure there are no metal coils.
Any advice is appreciated...
Other than the alcohol and cornstarch method, I'm thinking I will just probe around in the foam in the back and make sure there are no metal coils.
Any advice is appreciated...