eBIAB Schematic Wire Sizes

[rack04]

Planning a eBIAB build and I'm struggling to plan for wire sizes in my control panel. Here is the schematic I will be using. Can someone mark up this schematic to provide wire sizes? Thanks in advance.

 

[doug293cz]

You really ought to consider dumping the PID and going with an Auber DSPR110 controller. This has a "PID like" mode that is easier to tune than a PID, and a boil control mode that is much better than a PID in manual mode. Your controller can be as simple as the design below, or if you are looking for something different, I can work up a custom design.



The thicker wires need to be 10AWG, and the thinner wires can be anywhere from 20AWG to 10AWG (thinner wires are easier to work with.)
Brew on

 

[rack04]

Thanks for the reply. I've been living under a rock and didn't know that this type of controller existed. I'll need to do a little bit of reading to see how this controller works. It sounds like a very viable option especially since I'm trying to stay as cheap as possible.

 

[doug293cz]

@rack04

Here's the modified design you requested by PM. Let me know if this meets your requirements.



Brew on