Brian Dempsey
Member
- Joined
- Nov 12, 2018
- Messages
- 12
- Reaction score
- 0
Just finished building how my home electric setup (that i will post a bit later), powered by a raspberry pi, with craft beer pi as the software. Its version 3.
my questions is this, who is using this software, with what settings, for the heating element and what are they. Like hysteresis, PID, autoPID, or PID boil and what the the PID settings. been experimenting with settings, but i keep over shooting my target temp by about 3 degrees.
any advice is welcome. cheers!
Gimp
my questions is this, who is using this software, with what settings, for the heating element and what are they. Like hysteresis, PID, autoPID, or PID boil and what the the PID settings. been experimenting with settings, but i keep over shooting my target temp by about 3 degrees.
any advice is welcome. cheers!
Gimp
