Hi guys,
So today i finished work early, and as it was a nice day i decided to make a Milling Station for my Corona Mill.
I used to just attach it to my work bench but i got fed up of grain dust flying everywhere, and i also use my bench for my mash tun which is a big 170ltr Copper tun so i kept having to crush first then fill and heat mash after, this way i can do both at the same.time.
Its almost finished, i just need to add a door,at the front, fabricate a bigger hopper and also a catchment tube to allow the grain to fill the bucket without spraying all over the cupboard.
I door at the top is to allow adjustment without removing the mill.
I put this together from an old large cupboard which was all in pieces, so i just cut them down to size as required.
So today i finished work early, and as it was a nice day i decided to make a Milling Station for my Corona Mill.
I used to just attach it to my work bench but i got fed up of grain dust flying everywhere, and i also use my bench for my mash tun which is a big 170ltr Copper tun so i kept having to crush first then fill and heat mash after, this way i can do both at the same.time.
Its almost finished, i just need to add a door,at the front, fabricate a bigger hopper and also a catchment tube to allow the grain to fill the bucket without spraying all over the cupboard.
I door at the top is to allow adjustment without removing the mill.
I put this together from an old large cupboard which was all in pieces, so i just cut them down to size as required.
