BittererPlease
Active Member
Hey ya'll,
I just bought my first corny keg; used. It is in good condition, but I am going to referb it. Springs are good inside the ball joint. I ordered a new o-ring set. I am going to rinse it out a few times then let it sit with water for a while, then rinse it again.
Anyone have any other ideas to make sure that it is good to go for its first use?
Thanks,
ZK
I just bought my first corny keg; used. It is in good condition, but I am going to referb it. Springs are good inside the ball joint. I ordered a new o-ring set. I am going to rinse it out a few times then let it sit with water for a while, then rinse it again.
Anyone have any other ideas to make sure that it is good to go for its first use?
Thanks,
ZK