I am very reluctantly parting with my electric brewery. We are moving to Florida and it will be impossible to find a spot in our new home for an electric set up but we have a natural gas line available outside so I will be switching.
I will try to post pictures shortly. The best way to reach me is to send a PM as I am not always checking the forum. If you had any interest send me a PM with your email address and I can send pictures.
This is a 50 AMP set up, essentially based on Kal's. It easily runs two heat elements at the same time in the hot liquor tank and boil kettle. The set up also includes plugs for two pumps, PID's (Auber), SSR's, temperature controller wires, etc... It essentially mirrors Kal's.
The HLT is a repurposed fifteen gallon keg, with all stainless steel hardware, three piece ball valves with sight gauge and of course the plug & temperature probe.
The boil kettle is a twenty five gallon stainless steel kettle with three piece ball valves, plug & temperature probes, with sight gauge and pick up tube which gets the last drop of wort out of the kettle.
I can reuse everything else so these were the three pieces I was looking to part with. It is in a tool box currently but i have a new box that I was going to move everything over to in the future. This would be a great place to start and you could move over everything to a new box which would be a fun project.
This setup easily does a ten gallon batch and you can almost get to fifteen.
I was thinking $750 would be a good place to start but I am open to offers.
I have thirty or forty feet of 6 gauge wire running from my panel to the fifty amp plug which could be included but only if the you were qualified to disconnect the wire from the electrical panel.
There are lots of extra wires, connectors, contractors, etc... that would be included.
Please let me know if you have any questions. Thank You
I will try to post pictures shortly. The best way to reach me is to send a PM as I am not always checking the forum. If you had any interest send me a PM with your email address and I can send pictures.
This is a 50 AMP set up, essentially based on Kal's. It easily runs two heat elements at the same time in the hot liquor tank and boil kettle. The set up also includes plugs for two pumps, PID's (Auber), SSR's, temperature controller wires, etc... It essentially mirrors Kal's.
The HLT is a repurposed fifteen gallon keg, with all stainless steel hardware, three piece ball valves with sight gauge and of course the plug & temperature probe.
The boil kettle is a twenty five gallon stainless steel kettle with three piece ball valves, plug & temperature probes, with sight gauge and pick up tube which gets the last drop of wort out of the kettle.
I can reuse everything else so these were the three pieces I was looking to part with. It is in a tool box currently but i have a new box that I was going to move everything over to in the future. This would be a great place to start and you could move over everything to a new box which would be a fun project.
This setup easily does a ten gallon batch and you can almost get to fifteen.
I was thinking $750 would be a good place to start but I am open to offers.
I have thirty or forty feet of 6 gauge wire running from my panel to the fifty amp plug which could be included but only if the you were qualified to disconnect the wire from the electrical panel.
There are lots of extra wires, connectors, contractors, etc... that would be included.
Please let me know if you have any questions. Thank You