Blichmann Top Tier Center Mast

[jaguardoc504]

https://www.homebrewtalk.com/f51/blichmann-top-tier-burner-arm-mount-clone-390514/

The only thing I did was open the holes for the burner leg screws, the two I said were .375, and enlarged them another 1/32. You could maybe increase the bend angle another 1.5 degrees

They look great.
Might have to find a fab shop near the house to make these :fro:

 

[SligoDrinkingClub]

I'm picking up my center mast tomorrow, a 3.5"x3.5"x.125"x6' piece of mild steel. I plan to use threaded rod to pass through the tube to secure each shelf. With two burners, a large shelf for my 48L cooler, a march pump with mount, and the accessory tray for my plate chiller I think the .125" steel should hold just fine.

 

[SligoDrinkingClub]

Just did a dry fit-up today. I had to lower my top burner and shelf height, and my gas manifold will have to mount on to exposed threads from the burner arms. All in all a fun project. First brew next weekend!